Personally, I would go with the 20 gauge wire and a 2.5A fuse. That table tells you that you should have no smaller than 21 gauge wire for your circuit. Put 1.88A into the top table in this post. Based on the table above, each transformer draws 700mA, each Superflux LED draws 80mA, and the LED strip draws 80mA If you want to put all of these on a single circuit, you’ll need to know the current. Say you bought a cold cathode kit for each side of the dash (2 Transformers), 5 superflux LED’s for your vents, and a 4.7″ Flexible LED strip for your center console. You can use this value in the fuse size chart above to determine the minimum wire size required. Add the values and divide by 1000 to get your total current in Amps. To find the total amperage in your specific installation, refer to the table below.įind the items that you’re installing and their current requirements. Because of the low-current nature of the products at Oznium, most of the products, and the table that I’ve developed, have current listed in milliamperes or mA for short. One of the first questions to ask when planning your installation is what size wire to use, which will later determine what fuse to use.ĭon’t worry if you’re lost, you’re at Oznium, we’re helpful here.Ĭurrent is measured in Amperes, abbreviated to Amps or just the letter A. So you just bought your stuff at Oznium and are getting ready to plan your installation while USPS gets it to your door. Ex: 5A,10A,15A,20Aĭetermining the Total Amperage of your Circuit DO NOT EXCEED THE VALUES ON THIS TABLE! Common automotive blade-style fuses exist at 5A-20A in 5A Increments.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |